Report on DLink DI-701 v3.20 Firmware requested on 2000-12-04
Test
Section
Sub
Section
Detail
run-log
(help)
log 19:06:24: Fragmented scan: requested
  19:06:24: IP address: xxx.xxx.xxx.xxx
  19:06:24: Pings-of-death: requested
  19:06:24: Testing level: standard
  19:06:24: doing basic ICMP ping
  19:06:28: Running tcp SYN (half-open) portscan, source port 20, over 1-1024 plus 1026 common tcp service ports.
  19:36:44: Running tcp SYN (half-open) portscan, source port 20, over first 140 ports.
  19:36:44: using fragmented packets, which can get past some firewalls
  19:52:00: Running tcp FULL CONNECT portscan over 1-1024 plus services (limit 15 minutes).
  20:01:56: Attack with targa.
  20:01:56: Sending each different ping-of-death..
  20:02:02: Done Attack with targa.
  20:02:03: Attack with sping.
  20:02:05: Done Attack with sping.
  20:02:06: Attack with fawx.
  20:02:06: Done Attack with fawx.
  20:02:07: Attack with kod.
  20:03:38: Done Attack with kod.
  20:05:00: Running quick udp portscan over port 1-16
icmp
(help)
comment if your security logs are good, you may have logged a ping.
  advice To be totally invisible to the internet, your IP address should not even be pingable. No points are lost in this test for being pingable, as it is not a security risk.
  result Your address is pingable
udp
(help)
comment since all UDP ports are silent, there is no information.
  result Nothing can be determined about your UDP ports.
  target IP is silent, or throttling speed of UDP icmp return packets
  udp port scan would take too long! full udp scan cancelled.
smtphealth
(help)
result Cannot do requested SMTP server health check because I dont see port 25 open
nmap-syn
(help)
comment No results from the SYN (stealth) scan)
nmap-synfrag
(help)
comment fragmented packet scans are network intensive, so only first 140 ports are tried since if your firewall blocks services, it would certainly be trying to block something in this range.
nmap-tcp
(help)
comment No results from the basic TCP scan
nmap-syn
(help)
comment If your security is good, you get an alert of a scan attempt but this is a stealth scan, so it is difficult to detect.
nmap-synfrag
(help)
comment No results from the FRAGMENTED PACKET scan
nmap-udp
(help)
comment UDP Ports. Could not complete UDP scan because within the timeout allowed, we got no responses. It is probably you have an effective UDP firewall.
final
(help)
comment
Conclusion: FINAL SCORE: 0
  ** best result (I got no reaction at all from this IP)